Model No.: BL
1. For disassembling the DTH Hammer
2. Easy operation
3. Low cost
4. For 3" to 30" hammers
5. CE certificate
DTH Hammer Breaout Bench
It's a kind of bench to disassemble the dth hammers. The hammers range can be 3" to 30" (76mm to 760mm).
The operation method as below:
1). Put hammer on the bench.
2). Adjust the position of the hammer and wrench; Use wrench to block the top sub side of hammer; Let wrench and jack in the same face.
3). Fix K-shaped base with nut.
4). Fix wrench with nuts.
5). Shake handle of jack slowly till top sub away from hammer.
6). After top sub dismantled, grease the jack, release nuts, discharge the K-shaped base and turn around the hammer.
7). Adjust the position of hammer and wrench; Use wrench to block the drive chuck of hammer; Let wrench and jack in the same face.
8). Fix hammer
9). Fix K-shaped base and the wrench with nut.
10). Shake handle of jack slowly till drive chuck away from hammer.
Contact us if you need more details on Hammer Breakout Bench. We are ready to answer your questions on packaging, logistics, certification or any other aspects about DTH Hammer Breadkout Bench、Mining Hammer Breakout Bench. If these products fail to match your need, please contact us and we would like to provide relevant information.