Find Hydraulic Rock Splitter, Darda C12n, Splitting Cylinder C12n on Industry Directory, Reliable Manufacturer/Supplier/Factory from China.

Inquiry Basket (0)
Home > Products > Rock And Concrete Splitter > Flame Jet Cutting Machine Burner for Quarry Stone Cutting

Flame Jet Cutting Machine Burner for Quarry Stone Cutting

Basic Info

Model No.:  BLB45

Product Description

Model NO.: BLB45 Cutting Depth: 10m Air Consumption: 6cbm Per Minute Specification: as per order quantity HS Code: 82077090 Cutting Speed: 1-2 Square Meter Per Hour Cutting Seam Width: 80-100mm Trademark: none Origin: Xiamen, China Flame jet cutting machine is a way to cut rocks with high efficiency and the character of easily operation. It is driven by the diesel oil as the fuel, air compressor as the supporter of combustion. In virtue of spraying, heatingup, and burnning, then forming high tempreture through the spear mouth, and it will eject large flame to rocks, which make the thermal energy spread on the surface of the rock and break it rapidly, then forming stone pieces which will be blown by little wind layer by layer, demolishing gradually, and forming stone trench at last, it can enhance the mining speed several times comparing to the manual in the past, and features fast speed, high efficiency, non-demolishing the former texture, it is widely used to mine the granite stone.

Operation steps
1. Please refer to below photo, connect the water-filtter device, oil tank and control valve to the compressor in rigth way.
2. Then turn on the valve on air compressor. Open the oil switch and light some diesel in the fire-pan. Warm-up the head of the burner 10-15 minutes. Use the left hand to control the oil switch, while right hand controls the air switch. Open the air switch to 1/3 position first, then trun back quickly. Again open the air switch to 1/3 position. This process can inhale the warm-up flame into the burner. Slowly open the air switch and oil switch at this time, then open the air switch to the end. The fire is ignite after this.
Try to cut the block and check the flame. Adjust the oil switch according to the smoke and cutting speed. Start working after adjustment.
3. After the work, turn off the oil switch first, then turn off the air switch.

Notice:
1. Don't aim anyone while light the burner to avoid injuries.
2. Tie the connectors of air pipe and oil pipe tightly.
3. Air humidity will affect the normal work. Try to exclude the moisture in the air if possible.

One complete set of flame cutting machine including:
Diesel hose Φ 8mm: 50meter
Diesel tank: 1pc
Burner: 2pcs
Water/air filter device: 1pc
Flaming rod: 6meter
Nozzle: 1pc
Manometer: 1pc
Lighting plate: 1pc
Pressue oil filtter: 1pc
Cutting speed 1-2 m 2 /h
Cutting-seam width 80-100mm
Air pressure 0.6Mpa
Cutting depth 0-10m
Oil tank limited pressure 1.5Mpa
capacity of oil tank 850kgs
Inner diameter of oil tube 8mm
Inner diameter of Air Hose 25mm
Air consumption 6m 3 /min.
Fuel consumption (oil) 25-30kg/h

Contact us if you need more details on Flame Burner. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Fire Burner、Flame Jet Burner. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Rock And Concrete Splitter

Email to this supplier
  • *Subject:
  • To:

  • *Messages:
    Your message must be between 20-8000 characters